Skip to main content

Monitor Section

This section contains the controls:
  • Studio Monitor: determines which signal will be heard on the studio monitor speakers and headphones.
  • Control Monitor: assigns the signal to the control room monitor speakers and headphones.
  • CUE volume control.
  • Talk-Back button and microphone to the Studio.
  • Master “ON-AIR Mics” button. Activates the microphone channels and “ON-AIR” signals.
816 Monitor Panel
  1. Control room speaker level control.
  2. Adds CUE audio to the control room speakers (post-fader).
  3. Operator headphone level control.
  4. Signal assignment to the studio monitor output (headphones and speakers).
  5. Signal assignment to the control room monitor output (headphones and speakers).
  6. Level at which the CUE signal is added to the control room headphones and speakers.
  7. Talk-Back microphone (studio communication and intercom).
  8. Talk-Back pushbutton.
  9. Talk-Back microphone sensitivity.
  10. Microphone activation button.

Studio Monitor

  • Provides four signal sources: CUE, PGM, REC and ON-AIR [4].
  • The console sends signals with fixed level to both headphones and speakers.
  • For level distribution and control in the Studio, a headphone distribution amplifier is required, such as the optional Solidyne HD3 and HD5 modules.
See wiring in Installation ⟶ Monitoring

Monitor Control

  • Headphone level [3] and speaker level [1] are controlled independently.
  • Use the selector buttons [5] to choose the signal to monitor:
    • PGM: signal sent on-air.
    • REC: signal from the REC auxiliary bus.
    • ON-AIR: signal from an external tuner, recommended for on-air monitoring.
Adjust monitor speaker volume to a comfortable level with the SPEAKERS control in center position.
If the Studio-Transmitter Link or the audio processor introduces audible delay, it’s recommended to process the ON-AIR monitor signal with a delay-free processor connected directly to a PGM output from the console.

CUE Monitoring

Each channel features a CUE button that allows monitoring the signal before the fader (off-air). When multiple CUE signals are activated, they are summed together. The CUE signal can be routed to:
  • Control Room monitor speakers: press the MIX button [2].
  • Control Room headphones. This routing is fixed. CUE is summed with the signal selected by the monitoring source.
  • Studio monitor. Available as a signal source in STUDIO MONITOR.
CUE level is controlled exclusively by the CUE knob [6], affecting both headphones and speakers.
If the CUE [6] knob is turned down, the CUE signal will not be heard even if the headphone and speaker knobs are turned up.Conversely, if SPEAKERS [1] and HEADPHONES [3] are turned down, CUE will still be audible if the CUE knob is turned up.
Additional features:
  • CUE routing is mono.
  • To isolate CUE monitoring:
    • Reduce the monitoring level of SPEAKERS or HEADPHONES as appropriate.
    • Release PGM, REC and ON-AIR buttons.
We recommend monitoring the on-air signal at moderate volume and CUE at a higher level to clearly distinguish between them.

Studio Talkback

The talkback channel allows the operator to communicate with the announcer in the studio.
  • Press the TALK-BACK button.
  • Program audio in the control room speakers is muted to prevent feedback.
  • The operator is heard on the studio’s left channel.
  • The right channel maintains the on-air signal as a reference for announcers and reporters.
  • You can also activate CUE on the microphone channel to communicate with the announcer.
The talkback microphone level is factory-calibrated.
It should only be adjusted when absolutely necessary, using the LEVEL preset.